Energy control
-
Stelos 800 L
Stelos: Safety Instructions – read before use | Environment Stelos: Firmware update Stelos: User Interface | Controls | Functions | Handling Stelos: Technical Data Stelos: Remote control | Flash triggering Stelos: Power supply | Battery Stelos: Maintenance | Repair | Warranty Stelos: Accessories & Spare Parts Error messages
-
Satos
Safety Instructions – read before use | Environment Firmware update Satos User Interface | Controls | Functions | Handling Technical Data Remote control | Flash triggering Power supply | Battery Maintenance | Repair | Consumables | Spare parts | Guarantee Accessories Charging station for up to 4 slide-in batteries
- Pulso L
- Siros S
- Siros L
- Scoro E + S
- Move 1200 L
- RFS 2.1
- RFS 2.2
- RFS 3
- Pulso G, Unilite and Picolite
- LED F160
- Scope D50
- Compatibility (Lamp <-> light shaper | Lamp <-> power pack)
- Locate your distributor or dealer
-
Stelos 800 L
-
Satos
-
Pulso L
-
Siros S
-
Siros L
-
Scoro E + S
-
Move 1200 L
-
RFS 2.1
-
RFS 2.2
-
RFS 3
-
Pulso G, Unilite and Picolite
-
LED F160
-
Scope D50
-
Compatibility (Lamp <-> light shaper | Lamp <-> power pack)
-
Locate your distributor or dealer
The RFS 2.1 transceiver allows you to change the power outlet of all RFS 2 or RFS 2.1 flash units that are set to the same studio address (in "ST" mode), and to change the output of individual lamp channels (in "LP" mode). The output can be adjusted in 1/10 and full f-stops. ¨
Mode "ST"
- Briefly press the key "
" : all the RFS 2 or RFS 2.1 units increase the total energy by 1/10 f-stop - Briefly press the key "
": all the RFS 2 or RFS 2.1 units reduce the total energy by 1/10 f-stop - Press the key "" for more than a second: all the RFS 2 or RFS 2.1 units increase the total energy by 1 f-stop
- Press the key ""for more than a second: all the RFS 2 or RFS 2.1 units reduce the total energy by 1 f-stop
Mode "LP"
- Briefly press the key "": The lamp channel indicated increases its total output by 1/10 f-stop
- Briefly press the key "": The lamp channel indicated reduces its total output by 1/10 f-stop
- Press the key "" for more than a second: The lamp channel indicated increases its total output by 1 f-stop
- Press the key "" for more than a second: The lamp channel indicated reduces its total output by 1 f-stop
Resetting the device
To reset the device to factory settings, first press and hold the "test" key and then press the "set" key for more than four seconds. This resets the device.