Set the studio address
-
Satos
Safety Instructions – read before use | Environment Firmware update Satos User Interface | Controls | Functions | Handling Technical Data Remote control | Flash triggering Power supply | Battery Maintenance | Repair | Consumables | Spare parts | Guarantee Accessories Charging station for up to 4 slide-in batteries
- Pulso L
- Siros S
- Siros L
- Scoro E + S
- Move 1200 L
- RFS 2.1
- RFS 2.2
- Pulso G, Unilite and Picolite
- LED F160
- Scope D50
- Compatibility (Lamp <-> light shaper | Lamp <-> power pack)
- Locate your distributor or dealer
The transceiver must have the same studio address as the flash units or receivers that are to be used.
To set the studio address, please proceed as follows (the RFS 2.1 transceiver must be in "ST" mode. Should "LP" mode be selected, change to mode "ST" by pressing "set" for more than a second):
- Press the "set" key briefly until the display blinks "ST" and shows the studio number.
- Set the studio address with keys "
" and "
". - Save the setting by pressing the "set" key briefly. The transceiver synchronises with the flash units and "ST" is shown in the display (not blinking)