Safety Instructions -read before use
-
Satos
Safety Instructions – read before use | Environment Firmware update Satos User Interface | Controls | Functions | Handling Technical Data Remote control | Flash triggering Power supply | Battery Maintenance | Repair | Consumables | Spare parts | Guarantee Accessories Charging station for up to 4 slide-in batteries
- Pulso L
- Siros S
- Siros L
- Scoro E + S
- Move 1200 L
- RFS 2.1
- RFS 2.2
- RFS 3
- Pulso G, Unilite and Picolite
- LED F160
- Scope D50
- Compatibility (Lamp <-> light shaper | Lamp <-> power pack)
- Locate your distributor or dealer
Safety Instructions – read before use
Warning
Comply with the safety instructions provided, the instructions detailed below as well as the instructions applicable to accessories – it is mandatory to follow these!
This product is a professional photographic equipment, to be operated by professional personnel only.
The following basic safety precautions must be followed when using this product.
All transport protective materials and packaging on the product must be removed before use.
Carefully read and fully understand the instruction manual before use and strictly follow the safety instructions.
Dot not use damaged equipment or accessories. Allow professional repair technicians to inspect and confirm normal operation before continuing use after repairs.
Please disconnect the power when not in use.
This device is not waterproof. Keep it dry and avoid immersing it in water or other liquids. It should be installed in a ventilated and dry location and avoid using in rainy, humid, dusty, or overheated environments. Do not place items above the device or allow liquids to flow into it to prevent danger.
Do not disassemble without authorization. If the product malfunctions, it must be inspected and repaired by our company or authorized repair personnel.
Do not place the device near alcohol, gasoline, or other flammable volatile solvents or gases such as methane and ethane.
Do not use or store this device in potentially explosive environments.
Clean gently with a dry cloth. Do not use a wet cloth as it may damage the device.
This instruction manual is based on rigorous testing. Changes in design and specifications are subject to change without notice.
Use only specified charger and follow proper usage instructions for products with built-in lithium batteries, within the rated voltage and temperature range.
The product is powered by lithium battery, who has limited lifespan and will gradually lose its charging capacities, which is irreversible. As the battery ages, the product's battery life will decrease. The lifespan of lithium battery is estimated to be 2 to 3 years. Please regularly check the battery, and if the charging time significantly increases or the battery life significantly decreases, consider replacing the battery.
Unauthorized repairs will void the warranty and will incur charges.
Failures from improper operation is not covered under warranty.
The general broncolor safety instructions can be downloaded at
https://broncolor.swiss/safety
WARNING
Do not disassemble. Should repairs become necessary, this product must be sent to an authorised broncolor Service Center.
Always keep this product dry. Do not use in rain or damp conditions.
Keep out of reach of children .
Do not use in flammable and explosive environments. Pay attention to the relevant warning signs.
Do not leave or store the product if the ambient temperature reads over 50°C.
If a fault occurs, switch off the device immediately.
Warning
Operating frequency: 2412.99MHz - 2464.49MHz
Maximum EIRP: 9.52dBm