RFS 2.2 transceiver as receiver
-
Satos
Safety Instructions – read before use | Environment Firmware update Satos User Interface | Controls | Functions | Handling Technical Data Remote control | Flash triggering Power supply | Battery Maintenance | Repair | Consumables | Spare parts | Guarantee Accessories Charging station for up to 4 slide-in batteries
- Pulso L
- Siros S
- Siros L
- Scoro E + S
- Move 1200 L
- RFS 2.1
- RFS 2.2
- Pulso G, Unilite and Picolite
- LED F160
- Scope D50
- Compatibility (Lamp <-> light shaper | Lamp <-> power pack)
- Locate your distributor or dealer
With broncolor power packs, monolights and lamps from other manufacturers, which are not equipped to receive RFS 2 data, the unit can be used as an external receiver.
The unit will not be automatically switched to receive when connected to a power pack or monolight.
To switch from transmit mode to receive mode, or vice versa, please proceed as follows:
1) Hold the "test" key pressed and simultaneously switch the unit on.
2) Press the "LP" key and use the scrolling wheel to change to receive or transmit as appropriate.
3) Press the "LP" key again to confirm the selection, and switch the unit off.
When it is switched on again, the switchover will have been completed.
In receiver mode, the PC port will be automatically configured as an output. Connect the sync cable to the "out" socket of the RFS 2.2 transceiver and to the sync connection on the flash unit.