Information and fault signals - Move 1200 L
-
Stelos 800 L
Stelos: Safety Instructions – read before use | Environment Stelos: Firmware update Stelos: User Interface | Controls | Functions | Handling Stelos: Technical Data Stelos: Remote control | Flash triggering Stelos: Power supply | Battery Stelos: Maintenance | Repair | Warranty Stelos: Accessories & Spare Parts Error messages
-
Satos
Safety Instructions – read before use | Environment Firmware update Satos User Interface | Controls | Functions | Handling Technical Data Remote control | Flash triggering Power supply | Battery Maintenance | Repair | Consumables | Spare parts | Guarantee Accessories Charging station for up to 4 slide-in batteries
- Pulso L
- Siros S
- Siros L
- Scoro E + S
- Move 1200 L
- RFS 2.1
- RFS 2.2
- RFS 3
- Pulso G, Unilite and Picolite
- LED F160
- Scope D50
- Compatibility (Lamp <-> light shaper | Lamp <-> power pack)
- Locate your distributor or dealer
-
Stelos 800 L
-
Satos
-
Pulso L
-
Siros S
-
Siros L
-
Scoro E + S
-
Move 1200 L
-
RFS 2.1
-
RFS 2.2
-
RFS 3
-
Pulso G, Unilite and Picolite
-
LED F160
-
Scope D50
-
Compatibility (Lamp <-> light shaper | Lamp <-> power pack)
-
Locate your distributor or dealer
| Message in display | Description |
| Thermo 1 | Charging circuit overheated (cooling phase = 15 min) |
| Thermo 2 | Capacitors overheated (cooling phase = 60 min) |
| Thermo 3 | Resistors overheated (cooling phase = 3 min) |
| Thermo 4 | Battery overheated (cooling phase = 15 min) |
| Thermo 5 | Battery overheated (cooling phase = 20 min) |
| Accu low 20 % | Appears on reaching 20 % energy remaining in battery |
| Charge defect | Unit must be sent to Service for repair |
| Overvoltage | Unit must be sent to Service for repair |
| Defect lamp 1 / lamp 2 | Lamp 1 or lamp 2 is defective or not correctly connected |
| Use broncolor tubes | Please use only original broncolor flash tubes |
Acoustic fault indicator
If the flash fails to fire, a warning signal sounds for ca. 0.5 s and the display for the appropriate lamp blinks.
Acoustic signals
Beep sound:
End of charging or discharging
Double beep:
Energy demand above or below energy control setting via RFS 2 transmitter
"test" key held pressed for 4 s (reset to works settings)