The MobiLED lamp was developed to suit the Move 1200 L RFS 2 power pack: exceptionally compact and light, MobiLED has a tilt-and-swivel head for single-handed operation and an integral reflector mounting. The intelligent ventilation control only switches on when the operating temperature demands it. The unique design requires very little space for transport and storage.

The continuous operation mode of the Move 1200 L RFS 2 enables the use of powerful LEDs for modelling light so as to create new light design effects. Especially at the daylight colour temperature of 5500 K, it offers completely new possibilities for film sequences.
 

1. Replacing flash tubes
   Before you change the flash tube, be sure to disconnect the lamp from the power pack! Plug-in flash tubes are used.
   To change a flash tube, remove the snap ring and take out the protecting glass. Then pull the flash tube axially out of its socket. When replacing the flash tube make sure it is pushed in as far as it will go. Finally replace the protecting glass and secure it with the snap ring. Protecting glasses are available in the versions "UVE" art. no. 34.339.00 (5500 K) and "UVE matt" art. no. 34.340.00 (5500 K).
    
2. Lamp plugs
   Lamp plugs and connections are fitted with mechanical interlocks to prevent unintentional disconnection. To unplug, push down the locking spring below the cable guide and pull the plug out of its socket.
    
3. Extension cable to MobiLED
   The extension cable (3.5 m / 11.5 ft), available as an accessory under art. no. 34.150.00, is especially thin and flexible. It is only intended for use with MobiLED, Mobilite and Mobilite 2. If the cable is used with other lights, the modelling light and cooling fan will not operate.
    
4. Lamp fuses
   Use only sand-filled fuses of the type indicated on the type plate!
    
5. MobiLED continuous light adapter
   With the MobiLED lamp, the charger for Move 1200 L RFS 2 and the continuous light adapter, it is possible to use the modelling
   light independently of the power pack. For example, with the MobiLED operated directly from the mains power supply, a separate video sequence can be filmed in addition to the photo shooting.
    
6. Adapter to charger
   With the MobiLED lamp, the lithium battery for Move 1200 L RFS 2, the continuous light adapter and the adapter cable, it is possible to use the modelling light independently of the power pack and the mains power supply. With this arrangement, the MobiLED’s modelling light can be supplied with current directly from the battery.