Energy control -
-
Satos
Safety Instructions – read before use | Environment Firmware update Satos User Interface | Controls | Functions | Handling Technical Data Remote control | Flash triggering Power supply | Battery Maintenance | Repair | Consumables | Spare parts | Guarantee Accessories Charging station for up to 4 slide-in batteries
- Pulso L
- Siros S
- Siros L
- Scoro E + S
- Move 1200 L
- RFS 2.1
- RFS 2.2
- RFS 3
- Pulso G, Unilite and Picolite
- LED F160
- Scope D50
- Compatibility (Lamp <-> light shaper | Lamp <-> power pack)
- Locate your distributor or dealer
-
Satos
-
Pulso L
-
Siros S
-
Siros L
-
Scoro E + S
-
Move 1200 L
-
RFS 2.1
-
RFS 2.2
-
RFS 3
-
Pulso G, Unilite and Picolite
-
LED F160
-
Scope D50
-
Compatibility (Lamp <-> light shaper | Lamp <-> power pack)
-
Locate your distributor or dealer
Preparation
Longer press on key "ST": Turn the scrolling wheel as appropriate to change the studio channel up or down. Confirm the selection by a short press on key “ST”.
The RFS 2.2 transceiver allows you to change the energy setting of all RFS 2 flash units that are set to the same studio address (in the “ST” menu) and to change the output of individual lamp channels (in the “LP” menu). The output can be adjusted in 1/10 and full f-stop steps.
Menu "ST"
Short press on key "ST": Turn the scrolling wheel upwards or downwards to increase or reduce the total energy of all units. This takes place in 1/10 f-stop steps. Confirm the selection by a short press on key “ST”.
Menu "LP"
Short press on key "LP": Turn the scrolling wheel upwards or downwards to increase or reduce the energy of selected lamps. This takes place in 1/10
f-stop steps. Confirm the selection by a short press on key “LP”.